Don’t make the same mistake I did and just drop the line post right in your end post because it might be lost forever. ![]() So I used a 6′ tall 1 5/8″ line post to create an inner sleeve. This was a little more complicated because I couldn’t find any steel fence posts larger than 2 3/8″ in diameter to easily sleeve over top of the existing end post. I used this same method on the non-standard sized post at the back since the 2 3/8″ end post fit over it. I didn’t like that the posts made a rattling sound, so I squirted some spray foam in the posts to hold everything tight. The end posts should slide right over your 4′ line posts and give you the 6′ you need to support your fence panels. Using new 6′ end posts, cover the middle line posts like a sleeve. My existing steel fence posts were three different widths: a 2 3/8″ end post at the front where the gate was, two 1 5/8″ line posts in the middle, and a non-standard width post at the back. If your chainlink fence was already 6′ tall, lucky you, you can skip this step.Īdd height to the steel fence posts by creating a sleeve with a different width fence post. Then, roll up your chainlink and sell it to your dad for $10. Remove the top rail and all of the chainlink fencing that connects to your steel posts. I’ve talked about my frustration with the non-standard sized wood cross pieces in the Home Depot shadow box fence panels, so if you get your panels from Lowes or build them yourself, you might be able to skip a couple of these steps. I came up with a plan to bridge the gap in between the panels with a few extra pickets and shared this diagram a few obsessions ago. Meaning my standard 8′ wood fence panels wouldn’t be long enough to reach the steel posts to connect together with the Oz-Post brackets, and the steel posts weren’t tall enough to properly support the 6′ tall fence. Two: I wanted a 6′ tall fence and the existing chainlink fence was only 4′ tall. One: my chainlink fence was set up with the posts spaced 8’9″ apart instead of the standard 8′ spacing. I had two additional issues I needed to deal with. ![]() Oz-Post Steel 2 Wood Fence Bracket WAP-OZĭrill + Bits Turning a four-foot chainlink fence into a six-foot wood fenceĪs long as your steel posts are solidly in the ground, you should be able to convert your chainlink fence to a wood fence pretty easily. So when it came time to finish installing the fence along my driveway, I knew I was going to do everything I could to convert my chainlink fence to a wood fence and use the existing chainlink steel posts. That job was so terrible, I still have nightmares about cutting through several feet of bricks and clay. Last year, I moved the fence behind my garage five feet back and we used an auger to dig holes for the posts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |